How to Make a Long Slip and Slide

Co-authored by wikiHow Staff

Last Updated: February 21, 2022 Approved

One of the joys of summer recreation is the slip and slide. It's a fun way to beat the heat, be silly, and generally have a great time with friends. Sure, you can buy one at the store, but it's simple and inexpensive to make one at home. The best place to build one is on a grassy hill, but you can also make one right on the beach!

Method 1

Method 1 of 3:

Making a Simple Slide

Download Article

Choose something that is between 10 and 12 feet (3.05 and 3.66 meters) wide. Do not skimp and buy thin, flimsy plastic—it will rip and tear.
2
Spread the plastic sheet out on a grassy lawn. It would be best if you place the slide on a hill—even if it is a small one. The slight incline will help boost your speed.
- Smooth out any wrinkles or ripples with your hands.
Advertisement
It should now be around 5 or 6 feet (1.52 or 1.83 meters) wide. This will help make it even more durable and slide-like.^{[1]
X
Research source}
You will need a pin in each corner of the slide. You will also need to add more pins down the long side edges, about 5 to 10 feet (1.52 to 3.05 meters) apart. Use a hammer to drive the pins into the grass. You want them to be flush against the ground. If they are sticking out, you could get hurt when you use the slide.^{[2]
X
Research source}
This will help lubricate it and make it more slippery. You can use dish soap or even baby shampoo!
Grab a hose and turn it on. Spray water over the entire side. Don't worry if the excess water runs off the slide.^{[3]
X
Research source}

Method 2

Method 2 of 3:

Creating a Reinforced Slide

Download Article

1
Get a roll of heavy-duty plastic sheeting. Buy a roll of thick, plastic sheeting that is between 6 and 12 feet (1.83 and 3.66 meters) wide and 100 feet (30.48 meters) long. You can cut the plastic down shorter, if you want to, but don't make it narrower.
- Get thick plastic, around 6-mil. Don't skimp and get the cheap stuff—it will' tear.
2
Unroll the plastic sheet on a grassy lawn. It would be better if you unroll the plastic sheeting on a hill, even if it is a short one. The slight incline will help give you more speed on the way down.
- Smooth out any wrinkles or ripples with your hands.
3
Place pool noodles along the edges of the plastic. They need to be right on top of the plastic, a few inches/centimeters away from the edge. Keep the pool noodles 6 to 10 feet (1.83 to 3.05 meters) apart.^{[4]
X
Research source} You will need noodles along both of the long edges.
- Pool noodles are long, colorful tubes made from foam. You can find them in many stores during the summer.
4
Roll the edge of the plastic around the first pool noodle. Start with a pool noodle at the beginning of your slide. Roll the plastic around the noodle twice. Hold the pool noodle steady or have someone do it for you.^{[5]
X
Research source}
- If you don't have landscape anchor pins, place the pool noodle 1 foot (30.48centimeters) from the edge of the plastic sheeting.^{[6]
  X
  Research source}
5
Secure the noodle with landscape anchor pins. Hold the noodle in place, then drive a landscape anchor pin through it. You will need a pin at both ends of the noodle. Be sure to drive the pin straight down through the plastic and the noodle, right into the lawn.^{[7]
X
Research source} For extra security, add one in the middle as well.
- If you don't have landscape pins, fold the edge of the plastic over the pool noodle, and secure it with duct tape or packaging tape.^{[8]
  X
  Research source}
The noodles will help create a barrier. Not only will they prevent you from going outside the edges of the slide, but they will help keep the water in the slide as well. If you want to, you can add a pool noodle at the end of the slide as well to act as a buffer.
You can use dish soap, if you like, but baby soap would be even better. Run the soap down the middle of the slide. This will help lubricate the plastic and make it even more slippery.^{[9]
X
Research source}
Grab a hose and turn the water on. Spray the water onto the slide. You need just enough water to make it wet. Do not fill the slide like a mini pool.

Method 3

Method 3 of 3:

Setting Up a Beach Slide

Download Article

1
Smooth out the area for your slide. Use a shovel to clear an area that is 10 by 100 feet (3.05 by 30.48 meters). Add an extra 40 feet (12.92 meters) at the beginning for your "runway." Make sure that there are no rocks or shells in this 10 by 140-foot (3.05 by 42.67-meter) strip.^{[10]
X
Research source}
- For best results, choose something with a slight incline.
- Walk over the area and pat it down with your hands. This is important. Any sharp shells or rocks can not only cut the plastic but also you.
Buy a roll of plastic that is 10 to 12 feet (3.05 to 3.66 meters) wide and 100 feet long (30.48 meters). Make sure that you use thick, heavy-duty plastic, about 6-mil. Don't use the thin kind just because it is cheap; it will rip and tear.^{[11]
X
Research source}
You can do this by burying them in sand, about 1 to 2 feet (30.48 to 60.96 centimeters) on each side. You can also drive landscaping anchor pins into the edges instead. Use a hammer to drive the pins into the sand so that they don't stick out. Keep them 5 to 10 feet (1.52 to 3.05 meters) apart.^{[12]
X
Research source}
This will lubricate the plastic and make it even easier to glide along it. Use environmentally-friendly soap, if you can, such as unscented castile soap.^{[13]
X
Research source}
If you have access to a hose with fresh water, use that if possible. If you don't, grab some buckets and start gathering water from the sea. Pour enough water onto the plastic to make it wet.^{[14]
X
Research source}

Community Q&A

Search

Add New Question

Question

Can other people use it at the beach?

Community Answer

Yes, other people will likely want to use it if you are using it in public. If you are not comfortable with it, you should save it for when you are not in public.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 4 Helpful 7
Question

What if I just have a tarp?

Kendall Jayde

Community Answer

Works just fine! Cut it in half, then duct tape it and run water down it.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 12 Helpful 13
Question

How do I get bugs off a Slip n Slide?

Community Answer

Use a hose to wash them away.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 7 Helpful 10

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

Choose plastic that has a thickness of "6-mil." This a term for measuring the thickness of plastic. It's not 6 millimeters thick.^{[15]
X
Research source}

Thanks
Helpful 1 Not Helpful 1
Use baby wipes to clean off the soap/shampoo at the end.^{[16]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
Place the slide next to some sprinkles, then turn the sprinklers on. They'll spray you with water on the way down.^{[17]
X
Research source}

Thanks
Helpful 0 Not Helpful 0

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

Don't use black plastic. It will absorb the sunlight and get too hot.^{[21]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
Avoid building the slide on hard surfaces, like driveways or hard, dried, grass.^{[22]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
Do not stand or run down the slide. You can fall and get hurt.^{[23]
X
Research source}

Thanks
Helpful 0 Not Helpful 0
Allow only one person on the slide at a time.^{[24]
X
Research source}

Thanks
Helpful 0 Not Helpful 0